Bullnose Router Bits - 1/2" Shank

The bits look good, each in individual plastic box packages. Bearings also look well made, spin smoothly and lubricated.

Delivery to Moscow 2 weeks. Quality is good.

I was putting in new hardwood floors and had to do several stairs. When I priced what it would cost to buy the ready made bull nose pieces I found it was going to run me around $1000. Crazy!

Instead, I bought this bit and used it to create my own bullnose from the normal pieces of flooring. Worked great, and saved me a bunch of money.

Note that this is a hefty bit. Make sure your router is up to the job. Most variable speed 1/2' routers should be, but you can definitely notice the extra mass as it takes longer to spin up and down with this bit mounted. You'll want to slow the motor speed down a bit since the diameter is so large.

The cuts I got from white oak were fine. With the speed dialed in, I was getting nice piles of chips on the floor and virtually no burning. The bit seemed just as sharp after 20-something stairs as when I started.

No complaints. I'd buy it again.

Thus far, with only using on hard maple, they didn't burn, nor splinter out, as the carbide is a good quality!
I typically use freud only, but thought for the smaller project I needed just one of the bits to mill what I didn't have in my bit drawer already, for the price of the set, vs one bit from freud! No brainer! Unless after some fair amount of use proves otherwise, which after putting nearly 200 linear feet through on the 1/2" bit with no issues, so far so good!

High quality bit at a reasonable price. Worked very well. I ran 1000 lin ft of cedar 2x6 thru it so far to make staves for a barrel sauna. Clean cut, no issues. Felt as sharp for the last board as the first.